Documentation
    Preparing search index...

    Class Telemetry

    Message send by a Pixel to notify of its telemetry data.

    Implements

    • PixelMessage
    Index

    Constructors

    constructor

    Properties

    accXTimes1000 accYTimes1000 accZTimes1000 batteryControllerMode batteryControllerState batteryLevelPercent batteryState batteryTemperatureTimes100 channelIndex faceConfidenceTimes1000 faceIndex internalChargeState ledCurrent mcuTemperatureTimes100 rollState rssi timeMs type vCoilMaxTimes50 vCoilMinTimes50 vCoilTimes50 voltageTimes50 allowSkipLastProps

    Constructors

    Properties

    accXTimes1000: number
    accYTimes1000: number
    accZTimes1000: number
    batteryControllerMode: number

    Internal disabling of charging (because of temperature for instance)

    batteryControllerState: number

    The internal state of the battery controller itself.

    batteryLevelPercent: number

    The battery charge level in percent.

    batteryState: number

    The charging state of the battery.

    batteryTemperatureTimes100: number

    The battery temperature, in celsius, times 100 (i.e. 500 == 5 degrees C).

    channelIndex: number

    The data channel index of which the RSSI is measured.

    faceConfidenceTimes1000: number
    faceIndex: number

    Index of the face facing up (if applicable).

    internalChargeState: boolean

    Internal charge state

    ledCurrent: number

    led power draw in mA

    mcuTemperatureTimes100: number

    The microcontroller temperature, in celsius, times 100 (i.e. 500 == 5 degrees C). If the die was unable to read the temperature, value will be 0xffff.

    rollState: number

    Current roll state.

    rssi: number

    The RSSI value, in dBm.

    timeMs: number

    Firmware time in ms for when the data was gathered.

    type: number

    Type of the message.

    vCoilMaxTimes50: number

    The maximum measured coil voltage, multiplied by 50, over a short interval..

    vCoilMinTimes50: number

    The minimum measured coil voltage, multiplied by 50, over a short interval.

    vCoilTimes50: number

    The measured coil voltage multiplied by 50.

    voltageTimes50: number

    The measured battery voltage multiplied by 50.

    allowSkipLastProps: true

    The last few props may not be present on older firmware.

    Settings

    Member Visibility

    On This Page

    Constructors
    Properties